ADIC SNC 5100 Guide de l'utilisateur télécharger pdf (Page 94)

SNC 5100

86 Final Diagnostic Tests

6-00020-02

Step 3. If the test passes, remove the loop back plug and go to "Test SCSI

Port 1 and 2".

If the test does not pass, go to “Start MAP” on page 42.

Test SCSI Port 1 and 2

Step 1. Attach the appropriate VHDCI cable between SCSI 1 and 2.

Step 2. From the service terminal, enter the scsiChannelTest 1,2

command.

For more information, see the "scsiChannelTest (x,y)"

command on page 193.

Step 3. If the test passes, remove the loop back cable and go to "Test SCSI

Port 1 and 2".

If the test does not pass, go to “Start MAP” on page 42.

Test SCSI Port 3 and 4

Step 1. Attach the appropriate VHDCI loop back cable between SCSI 3

and SCSI 4.

Step 2. From the service terminal, enter the

scsiChannelTest 3,4

command.

For more information, see the "scsiChannelTest (x,y)"

command on page 193.

Step 3. If the test passes, remove the loop back cable and go to "Ethernet

Test".

If the test does not pass, go to “Start MAP” on page 42.

Ethernet Test

For further information about the procedures and commands used in this

section, see “Connecting to the Service Port” on page 95 and “Diagnostic

Command Reference” on page 187.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 227 228

Pas de commentaire

ADIC SNC 5100 Guide de l'utilisateur Page 94